Sony STR-DA5200ES Operating Instructions (Large File - 23.24 MB) - Page 110

2 Press V/v repeatedly to select the item, then press . Item Explanation RETRY Re-performs the auto calibration. SAVE EXIT Saves the measurement results and exits the setting process. WRN CHECK Displays a warning concerning the measurement results. See "When you select "WRN CHECK"" (page 47). PHASE INFO Displays the phase of each speaker (in phase/out of phase). See "When you select "PHASE INFO"". DIST.INFO Displays the measurement result for speaker distance. LEVEL INFO Displays the measurement result for speaker level. EXIT Exits the setting process without saving the measurement results. 3 Press . The measurement results are saved. 4 Press V/v repeatedly to select "AUTO EQ," then press . 5 Press V/v repeatedly to select the parameter, then press . AUTO EQ type Explanation ENGINEER Sets the frequency characteristics to a set that matches that of the Sony listening room standard. FULL FLAT Makes the measurement of frequency from each speaker flat. FRONT REF Adjusts the characteristics of all the speakers to match the characteristics of the front speaker. OFF Set the auto calibration type to off. 110GB Tip The size of a speaker (LARGE/SMALL) is determined by the low characteristics. The measurement results may vary, depending on the position of the optimizer microphone and speakers, and the shape of the room. It is recommended that you follow the measurement results. However, you can change those settings in the Auto Calibration settings menu (page 71). Save the measurement results first, then try to change the settings if you want. When you select "PHASE INFO" You can check the phase of each speaker (in phase/out of phase). Press V/v repeatedly to select a speaker, then press to return to step 1 in "Confirming/saving the measurement results." Display IN-PHASE OUT-OFPHASE ---------- Explanation The speaker is in phase. The speaker is out of phase. The "+" and "-" terminals of the speaker may be connected the other way around. However, depending on the speakers, "OUT-OF-PHASE" appears on the display even though the speakers are connected properly. This is because of the speakers' specifications. In this case, you can continue to use the receiver. No speakers are connected. Tip Depending on the position of the sub woofer, the measurement results for polarity may vary. However, there will be no problems even if you continue to use the receiver with that value. Selecting a sound field type For details on each sound field type, see "Enjoying a pre-programmed sound field" (page 58). Press 2CH, A.F.D., MOVIE, or MUSIC repeatedly. The selected sound field type appears on the display.