Sony STR-DA5200ES Operating Instructions (Large File - 23.24 MB) - Page 124

Changing button assignments (RM-AAU009 only) You can change the factory settings of the input buttons to suit the components in your system. For example, if you connect a DVD player to the VIDEO 2 IN jacks on the receiver, you can set the VIDEO 2 button on this remote to control the DVD player. Note, however, that the settings of the TUNER button cannot be changed. 1 2,3 4 1 Press RM SET UP for more than 2 seconds. The indicator lights up. 2 Press the input button of which you want to change the assignment. The indicator turns off once and turns on again when a valid button is pressed. Only the first input button that is pressed will be registered. Example: Press VIDEO 2. 124GB 3 Referring to the table below, press the input button for the category you want. The indicator turns off when a valid button is pressed. Example: Press DVD once. 4 Press SOURCE. The new assignment is registered. The indicator slowly lights up twice, then goes off. To cancel Press RM SET UP during any step. Tip If the operation is unsuccessful, the indicator flashes four times and the remote automatically exits the button assignment mode. In this case, the new assignment is not registered and the previous setting remains. Notes • If you do not press a button during step 2 through 4 within 60 seconds, the remote automatically exits the button assignment mode. Start again from step 1. • In step 3, if you press the same button more than the possible number of categories that can be selected, only the last category is registered for the new assignment. Valid buttons and the corresponding categories Corresponding categories VTR-1 VTR-2 VTR-3 VTR-4 VTR-5 VTR-6 DVD player LD player TV Press VIDEO 1 once VIDEO 2 once VIDEO 3 once VIDEO 1 twice VIDEO 2 twice VIDEO 3 twice DVD once DVD twice TV/SAT once