Sony STR-DA5200ES Operating Instructions (Large File - 23.24 MB) - Page 70

8 Press V/v repeatedly to select the position number, then press or b. You can rename the position number, refer to "Naming inputs" (page 92). 9 Press V/v repeatedly to select "Manual Setup," then press or b. 10 Press OPTIONS, then select "Speaker Pattern". Select "Speaker Pattern" according to the speaker system which you are using. You do not need to select the speaker pattern after auto calibration. 11 Press V/v repeatedly to select the speaker pattern you want. 12 Press OPTIONS. 70GB 13Press V/v repeatedly to select "Test Tone," then press . The test tone is output from each speaker in sequence. You can select the test tone type. For details, see "Option menu parameters of Auto Calibration settings" (page 73). 14Select the speaker you want to adjust, then adjust the parameter using V/v. Tips • To adjust the level of all speakers at the same time, press MASTER VOL +/-. • The adjusted value is shown on the display during adjustment. 15Press V/v repeatedly to select "OFF," and then press . The test tone turns off. When a test tone is not output from the speakers • The speaker cords may not be connected securely. Check to see if they are connected securely and cannot be disconnected by pulling on them slightly. • The speaker cords may have the short-circuit problem. When a test tone is output from a different speaker than the speaker displayed on the screen The speaker pattern to the connected speaker is not set up correctly. Make sure the speaker connection and the speaker pattern match. For more precise adjustment You can output the test tone or sound source from two adjacent speakers to adjust their balance and level. Then select the two speakers you want to adjust using "Phase Audio" or "Phase Noise" in the Auto Calibration settings menu (page 73).