Yamaha MO8 Owner's Manual - Page 72
Changing Control Change numbers, Using the Controllers for two different functions
UPC - 641018006938
View all Yamaha MO8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Quick Guide Using the Controllers-Advanced Course Controllers supported by the MO Changing Control Change numbers The functions assigned to the controllers by the Controller Set and ASSIGN A/B functions are applied only to the internal tone generator block. For connected external MIDI instruments, use of the controllers generates MIDI Control Change messages, as assigned in the chart below. External MIDI instrument Transmitting the Control Change messages Controller Affecting the destination (Dest) Tone generator block Controller Aftertouch* Pitch Bend wheel Modulation wheel ASSIGN A, B Footswitch Ribbon Controller* ASSIGN 1, 2 Foot Controller 1, 2* Breath Controller* Generated MIDI message Channel Aftertouch (DnH) Pitch Bend (EnH) Control Change (BnH, 01H) Control Change (BnH) Control Change (BnH) Control Change (BnH) Display for setting the Control Change number - - - [UTILITY] → [F4] CTL ASN → [SF2] ASSIGN [UTILITY] → [F4] CTL ASN → [SF3] FT SW [VOICE] → [UTILITY] → [F3] VOICE → [SF4] CTL ASN [PERFORM] → Performance selection → [EDIT] → [COMMON] → [F4] CTL ASN [SONG]/[PATTERN] → Song/Pattern selection → [MIXING] → [EDIT] → [COMMON] → [F4] CTL ASN * The MO does not have the following MIDI controllers: Aftertouch, Ribbon Controller, Foot Controller 2 jack, or Breath Controller jack. However, keep in mind that if the same MIDI Control Change messages as set here are received from an external device, the internal tone generator also responds to those messages as if the unsupported/unavailable MIDI controller was used on the MO. Conventional controllers, such as Modulation wheel, will affect connected MIDI instruments in their conventional way. For example, when the pan function is assigned to the Modulation wheel under Controller Set, using the Modulation wheel will apply the pan function to the internal tone generator, but will transmit the Modulation messages to an external MIDI instrument. Keep in mind also that if the same MIDI Control Change messages as set here are received from an external device, the internal tone generator also responds to those messages as if the controller on the MO itself was used. TIP Using the Controllers for two different functions You can also set up a controller such that it sends one kind of Control message to the internal tone generator of the MO, yet another kind of message to the MIDI Out. For example, in a Controller Set you could assign Resonance to ASSIGN 1 (Knob 3). Then, in the Utility mode, you could assign Control Change number 1 (modulation) to the same Knob. Now, when you move Knob 3, resonance will be applied to the sound of the internal tone generator block, while modulation messages will be transmitted to the external MIDI instrument. 72 Owner's Manual