Yamaha Tyros2 Owner's Manual - Page 99

Reference Voice Creator-Custom Voice Edit 14 Edit the voice by using the Voice Set parameters. Before saving, edit the parameters of your new voice. 1) Press the [EXIT] button to show the WAVE IMPORT display. 2) Press the [VOICE SET] LCD button ([E] button). For details on the Voice Set parameters, refer to the section "Editing a Voice" on page 91. 3) Press the [EXIT] button to show the WAVE IMPORT display again. 15 Save and assign the newly created voice. Press the [SAVE] LCD button ([J] button). The Save operation is actually a two-step process: CAUTION • The created voice will be lost if you change to another voice or you turn the power off without executing the save operation. Make sure to execute the save operation. Step 1-Save the voice to a storage device This step ensures that the data will be available, even in the event of a power failure or accidental shut down. 1) Press the [SAVE FILE] LCD button ([G] button). 2) Select the location and folder, using the [TAB] buttons and LCD buttons. Create a folder if necessary by pressing the [FOLDER] LCD button (lower [7] button). 3) Press the [SAVE] LCD button (lower [6] button). 4) Enter a name for the voice. (See page 76.) 5) Press the [OK] LCD button (upper [8] button). NOTE • Each time you add a Wave to the Element (or add an Element to the voice), you should save the voice. Simply keep the same name for the voice, and overwrite the data each time. (At the confirmation prompt, select [YES] with the [F] button.) • Saving the voice to the USER drive is not recommended since the USER drive does not have much memory space-only about 3 MB. • Do not use any special characters (umlaut, accent, etc.) in the voice name. 99 Tyros2 Owner's Manual