ZyXEL NBG-418N v2 User Guide - Page 140
Access Point, Universal Repeater
View all ZyXEL NBG-418N v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Chapter 19 Sys OP Mode Figure 107 Maintenance > Sys Op Mode > General: Router • In this mode there are both LAN and WAN ports. The LAN Ethernet and WAN Ethernet ports have different IP addresses. • The DHCP server on your device is enabled and allocates IP addresses to other devices on your local network. • The LAN IP address of the NBG-418N v2 is set to 192.168.1.1. • You can configure the IP address settings on your WAN port. Contact your ISP or system administrator for more information on appropriate settings. If you select a non-router mode (Access Point, or Universal Repeater) the following pop-up message window appears. Figure 108 Maintenance > Sys Op Mode > General: Non-Router • In non-router mode, all Ethernet ports have the same IP address. • All ports on the rear panel of the device are LAN ports, including the port labeled WAN. There is no WAN port. • The DHCP server on your device is disabled. In this mode there must be a device with a DHCP server on your network such as a router which can allocate IP addresses or else you need to manually assign IP addresses to devices on your network. • The LAN IP address of the NBG-418N v2 is set to 192.168.1.2. NBG-418N v2 User's Guide 140