1996 Ford Windstar Owner's Manual - Page 134

The Speed Dependent feature comes disabled from the factory, but can be activated at any time by using the following procedure. 1. Make sure the two front doors are securely closed. 2. Insert the key into the ignition and turn first to the ON position (the gauges on the instrument panel will not illuminate) and then back to the OFF position. Remove the key and within 30 seconds: 3. Press and hold the washer button on the end of the turn signal lever. 4. Within two seconds, put the key back in the ignition and turn to the ON position. 5. Hold the washer button down until a long (two second) tone is heard. Release the button while the tone is active. 6. After the long tone, a confirmation sequence will be heard. One beep indicates the feature is inactive. Two beeps indicates the feature is active. Repeat this procedure any time you want to cancel or reactivate the Speed Dependent feature. Windshield Washer To clean the windshield, push in the washer button on the end of the turn signal lever. For a constant spray, push and hold the button. If the windshield wipers are off, one momentary push results in one wipe and a longer push in three wipes and activation of washer fluid. If the windshield wipers are in interval mode a quick tap results in two wipe cycles and a longer tap in three wipes and washer fluid activation. Do not try to clean the windshield when the washer fluid container is empty and never activate the washers for more than fifteen seconds continuously. This could damage the washer pump system. 132