1996 Ford Windstar Owner's Manual - Page 200

s Using the "SCAN/TUNE" button to scan radio stations Pressing the "SCAN/TUNE" button once enters the scan mode (display will indicate "SCN"). Pushing the top a half of the "SEEK" button will begin the scan mode up the frequency band, stopping on each listenable station for approximately five seconds. Pushing the bottom b half of the "SEEK" button will begin the scan mode down the frequency band, again stopping on each listenable station for approximately five seconds. To stop the scan mode on the presently sampled station press the "SCAN/TUNE" button again. s Setting the station MEMORY PRESET buttons Your radio is equipped with 5 station memory buttons. These buttons can be used to select up to 5 preset AM stations and 10 FM stations (5 in FM1 and 5 in FM2). Follow the easy steps below to set these buttons to the desired frequencies. 1. Select a band, then select a frequency. 2. Press one of the memory buttons and hold the button until the sound returns. That station is now held in memory on that button. 3. Follow the two steps above for each station memory preset button you want to set. Using the Automatic Memory Load and Automatic Memory Store features NOTE: If no stations are in memory presets, you can activate the feature by pressing and holding the "AUTO PRESET" button for approximately three seconds. Auto Memory Load sets all memory buttons in AM, FM1 and FM2 sequentially by seeking out the first five strong stations for the respective band and storing them in memory buttons 1-5. (FM2 will store the second set of strong stations from the FM band.) 198