1996 Ford Windstar Owner's Manual - Page 354

To install a bulb: 1. With the flat side of the bulb's plastic base facing upward, insert the glass end of the bulb into the socket. You may need to turn the bulb left or right to line up the grooves in the plastic base with the tabs in the socket. When the grooves are aligned, push the bulb into the socket until the plastic base contacts the rear of the socket. Do not touch the glass with your fingers. 2. Snap the retaining clip over the plastic base. 3. Push the electrical connector into the rear of the plastic base until it snaps, locking it into place. 4. Turn the headlamps on and make sure that they work properly. If the headlamp was correctly aligned before you changed bulbs, you should not need to align it again. Replacing the Taillamp Bulbs To remove a bulb: 1. Open the liftgate. 2. Remove two screws along top edge of taillamp lens. 3. Grasp lens with fingers at point B and pull side of lens out until snap attachment releases. 354