2006 Infiniti FX35 Owner's Manual - Page 31

CHILD RESTRAINT INSTALLATION ON REAR SEAT OUTBOARD OR CENTER POSITIONS WARNING The three-point seat belt in your vehicle is equipped with an automatic locking mode retractor which must be used when installing a child restraint. Failure to use the automatic locking mode will result in the child restraint not being properly secured. The restraint could tip over or otherwise be unsecured and cause injury to the child in a sudden stop or collision. When installing a child restraint system in the rear center position both the center seat belt connector tongue and buckle tongue must be secured. See "Attaching rear center seat belt" earlier in this section. Front facing Rear outboard seat SSS0252A When you install a child restraint in a rear outboard or center seat, follow these steps: 1. Position the child restraint on the seat. Always follow the child restraint manufacturer's instructions. The back of the child restraint should be secured against the vehicle seatback. If necessary, adjust or remove the head restraint to obtain the correct child restraint fit. See "Head restraint adjustment" earlier in this section. If the head restraint is removed, store it in a Rear center seat secure place. Be sure to install the head restraint when the child restraint is removed. If the seating position does not have an adjustable head restraint and it is interfering with the proper child restraint fit, try another seating position or a different child restraint. SSS0342 Safety - Seats, seat belts and supplemental restraint system 1-21