2010 Jeep Wrangler Owner's Manual - Page 148

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 147 System can be reactivated by pushing the Electronic To Set a Desired Speed Speed Control ON/OFF button and resetting the desired Turn the Electronic Speed Control ON. When the vehicle has reached the desired speed, press down on the lever vehicle set speed. and release. Release the accelerator and the vehicle will To Activate operate at the selected speed. Push the ON/OFF button. The Cruise Indicator Light in the instrument cluster will illuminate. To turn the Elec- NOTE: The vehicle should be traveling at a steady tronic Speed Control system off, push the ON/OFF speed and on level ground before pressing the SET lever. button a second time. The cruise indicator light will turn To Deactivate off. The Electronic Speed Control system should be A soft tap on the brake pedal, pulling the Electronic turned off when not in use. Speed Control lever toward you, or normal brake or clutch pressure while slowing the vehicle will deactivate WARNING! Electronic Speed Control without erasing the set speed Leaving the Electronic Speed Control system on memory. Pressing the ON/OFF button or turning the when not in use is dangerous. You could accidentally ignition switch OFF erases the set speed memory. set the system or cause it to go faster than you want. To Resume Speed You could lose control and have an accident. Always To resume a previously set speed, push the RESUME leave the Electronic Speed Control system off when ACCEL lever up and release. Resume can be used at any you are not using it. speed above 25 mph (40 km/h). 3