2010 Jeep Wrangler Owner's Manual - Page 352

STARTING AND OPERATING 351 To activate the system, press the bottom of the AXLE LOCK switch once to lock the rear axle only (the "Rear Axle Lock Indicator Light" will illuminate), press the bottom of the switch again to lock the front axle (the "Front Axle Lock Indicator Light" will illuminate). When the rear axle is locked, pressing the switch again will lock or unlock the front axle. NOTE: The indicator lights will flash until the axles are fully locked or unlocked. REAR AXLE LOCK (FOUR-WHEEL DRIVE NON-RUBICON MODELS) - IF EQUIPPED The REAR AXLE LOCK switch is located on the lower switch bank (below the climate controls). This feature will only activate when the following conditions are met: • Key in ignition, vehicle in 4L (Low) range. • Vehicle speed should be 10 mph (16 km/h) or less. 5 To unlock the axles, press the top of the AXLE LOCK To activate the system, press the REAR AXLE LOCK switch down to lock the rear axle (the "Rear Axle Lock switch. Indicator Light" will illuminate); press the switch up to Axle lock will disengage if the vehicle is taken out of 4L unlock the rear axle. (Low) range, or the ignition switch is turned to the OFF NOTE: The indicator lights will flash until the axle is position. fully locked or unlocked.