2010 Jeep Wrangler Owner's Manual - Page 354
2010 Jeep Wrangler Manual
Page 354 highlights
STARTING AND OPERATING 353 when activation conditions are not met. The stabilizer/ To disconnect the stabilizer/sway bar, shift to either 4H sway bar should remain in on-road mode during normal or 4L and press the SWAY BAR switch to obtain the driving conditions. off-road position. Refer to "Four-Wheel Drive Operation" in "Starting and Operating" for further information. The WARNING! "Sway Bar Indicator Light" will flash until the stabilizer/ sway bar has been fully disconnected. Do not disconnect the stabilizer bar and drive on hard-surfaced roads or at speeds above 18 mph NOTE: The stabilizer/sway bar may be torque locked (29 km/h); you may lose control of the vehicle, which due to left and right suspension height differences. This could result in serious injury. The front stabilizer bar condition is due to driving surface differences or vehicle enhances vehicle stability and is necessary for main- loading. In order for the stabilizer/sway bar to taining control of the vehicle. The system monitors disconnect/reconnect, the right and left halves of the bar vehicle speed and will attempt to reconnect the must be aligned. This alignment may require that the stabilizer bar at speeds over 18 mph (29 km/h). This is vehicle be driven onto level ground or rocked from side indicated by a flashing or solid "Sway Bar Indicator to side. Light." Once vehicle speed is reduced below 14 mph To return to on-road mode, press the SWAY BAR switch (22 km/h), the system will once again attempt to again. return to off-road mode. 5