2010 Jeep Wrangler Owner's Manual - Page 499

498 MAINTAINING YOUR VEHICLE BULB REPLACEMENT 6. Remove the lamp from the collar. NOTE: Lens fogging can occur under certain atmo- 7. Grasp the bulb and turn 1/4 turn counterclockwise. spheric conditions. This will usually clear as atmospheric 8. Pull the bulb from the housing. conditions change to allow the condensation to change back into a vapor. Turning the lamps on will usually 9. Push connector locking tab to the unlock position. accelerate the clearing process. 10. Remove connector from bulb. Headlamp 11. Push connector onto new bulb base, and push the 1. Open hood and support using prop rod. connector locking tab to the lock position. 2. Remove the front grille. Turn the retainers along the top 1/4 turn counterclockwise and remove. 3. Pull the bottom of the grille away starting at one side and working toward the other. 4. Turn both park and turn signal socket assemblies 1/4 turn counterclockwise and remove. CAUTION! Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life. If the bulb comes in contact with any oily surface, clean the bulb with rubbing alcohol. 12. Reinstall bulb housing. Rotate the bulb 1/4 turn 5. Remove the four screws holding the metal retaining clockwise. ring.