2010 Jeep Wrangler Owner's Manual - Page 17
2010 Jeep Wrangler Manual
Page 17 highlights
16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 4. Insert a blank Sentry Key into the ignition switch. Turn the ignition switch to the ON position within 60 seconds. After 10 seconds, a single chime will sound. In addition, the Vehicle Security Light will stop flashing. To indicate that programming is complete, the Vehicle 1. Cut the additional Sentry Key Transponder blank(s) Security Light will turn on again for three seconds and to match the ignition switch lock cylinder key code. then turn off. 2. Insert the first valid key into the ignition switch. Turn The new Sentry Key is programmed. The Remote the ignition switch to the ON position for at least three Keyless Entry (RKE) transmitter will also be proseconds, but no longer than 15 seconds. Then, turn the grammed during this procedure. ignition switch to the LOCK position and remove the first Repeat this procedure to program up to eight keys. If you key. do not have a programmed Sentry Key , contact your 3. Insert the second valid key into the ignition switch. authorized dealer for details. Turn the ignition switch to the ON position within 15 seconds. After 10 seconds, a chime will sound. In NOTE: If a programmed key is lost, see your authorized addition, the Vehicle Security Light will begin to flash. dealer to have all remaining keys erased from the sysTurn the ignition switch to the LOCK position and tem's memory. This will prevent the lost key from starting your vehicle. The remaining keys must then be remove the second key. Customer Key Programming If you have two valid Sentry Keys , you can program new Sentry Keys to the system by performing the following procedure: