2010 Jeep Wrangler Owner's Manual - Page 26
2010 Jeep Wrangler Manual
Page 26 highlights
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 25 To Enter Remote Start Press and release the REMOTE START button on the RKE transmitter twice, within five seconds. The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will start and the vehicle will remain in the Remote Start mode for a 15-minute cycle. NOTE: • The park lamps will turn on and remain on during Remote Start mode. Remote start will also cancel if any of the following occur: • The engine stalls or RPM exceeds 2500 • Any engine warning lamps come on • The hood is opened • The hazard switch is pressed • The transmission is moved out of PARK • The brake pedal is pressed 2 To Exit Remote Start Mode without Driving the • For security, power window operation is disabled Vehicle when the vehicle is in the Remote Start mode. Press and release the REMOTE START button one time, • The engine can be started two consecutive times (two or allow the engine to run for the entire 15-minute cycle. 15-minute cycles) with the RKE transmitter. However, NOTE: To avoid unintentional shut downs, the system the ignition switch must be cycled to the ON position will disable the one time press of the REMOTE START before you can repeat the start sequence for a third button for two seconds after receiving a valid Remote cycle. Start request.