2010 Jeep Wrangler Owner's Manual - Page 21

20 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE To Unlock the Doors and Swing Gate Press and release the RKE transmitter UNLOCK button once to unlock the driver's door only, or twice to unlock all the doors and swing gate. When the RKE transmitter UNLOCK button is pressed, the Illuminated Entry will initiate and the parking lights will flash twice. 4. Test this feature while outside of the vehicle, by pressing the LOCK/UNLOCK button on the RKE transmitter. NOTE: Pressing the RKE transmitter LOCK button while you are inside of the vehicle will activate the Vehicle Security Alarm. Opening a door with the Vehicle The system can be programmed to unlock all the doors Security Alarm activated will cause the alarm to sound. upon the first RKE transmitter UNLOCK button press, Press the RKE transmitter UNLOCK button to deactivate using the following procedure: the Vehicle Security Alarm. 1. Press and hold the LOCK button on a programmed 5. If the desired programming was not achieved or to RKE transmitter. reactivate this feature, repeat the above steps. 2. Continue to hold the RKE transmitter LOCK button for at least four seconds, but not longer than 10 seconds, then press and hold the RKE transmitter UNLOCK button. 3. Release both buttons at the same time. To Lock the Doors and Swing Gate Press and release the LOCK button on the RKE transmitter to lock all doors. The turn signals will flash and the horn will chirp once to acknowledge the lock signal. If desired, the "Sound Horn On Lock" feature can be turned on or off using the following steps: