2007 Nissan Murano Owner's Manual - Page 275

1. Park the vehicle on a level surface and apply the parking brake. 2. Run the engine until it reaches operating temperature. 3. Turn the engine off and wait more than 10 minutes. 4. Place a large drain pan under the drain plug A k (under the body). B 5. Remove the oil filler cap k (inside the engine compartment). A 6. Remove the drain plug k with a wrench and completely drain the oil. washer. Securely tighten the drain plug with a wrench. Drain plug tightening torque: 22 to 29 ft-lb (29 to 39 N⋅m) Do not use excessive force. 8. Refill engine with recommended oil and install the cap securely. CAUTION Never pull out the oil level gauge while filling engine oil. See "Capacities and recommended fuel/lubricants" in the "9. Technical and consumer information" section for drain and refill capacity. The drain and refill capacity depends on the oil temperature and drain time. Use these specifications for reference only. Always use the dipstick to determine the proper amount of oil in the engine. 9. Start the engine. Check for leakage around the drain plug. Correct as required. 10. Turn the engine off and wait more than 10 minutes. Check the oil level with the dip- If oil filter is to be changed, remove and replace it at this time. See later in "Engine oil" for changing engine oil filter. CAUTION SDI1763 CHANGING ENGINE OIL Change the engine oil and filter according to the maintenance log shown in the Service and Maintenance Guide. Be careful not to burn yourself, as the engine oil is hot. ¼ Waste oil must be disposed of properly. ¼ Check your local regulations. 7. Clean and re-install the drain plug with a new 8-10 Maintenance and do-it-yourself