1995 Oldsmobile 88 Owner's Manual - Page 269

Using Foam-Qpe Cleaner on Fabric 0 Vacuum and brush area to remove anyloose dirt. the Always clean a whole panel or section. Mask trim surrounding trim along stitch or welt lines. directions onthe container label. NOTICE: Be careful. A blow dryer may scorch the fabric. Wipe with a clean cloth. 0 e Mix Multi-Purpose Powdered Cleaner following the 0 0 Use suds only and apply with clean sponge. a Don't saturate the material. Using Solvent-Type Cleaner on Fabric First, see if youhave to use solvent-type cleaner at all. Some spots and stains will clean better withjust off water and mild soap. If you need to a solvent: use 0 e Don't rub it roughly. e As soon as you've cleaned the section, use a sponge to removethe suds. 0 0 Rinse the section with a clean, wet sponge. Wipe off what's left with a slightly damp paper towel or cloth. Then dry it immediately with a blow dryeror a heat lamp. 0 0 Gently scrape excess soil from the trim material with a clean, dull knife scraper. Use very or little cleaner, light pressure and clean cloths (preferably cheesecloth). Cleaning should start at the outside of the stain, "feathering" toward the center. Keep changing to a clean section the cloth. of When you clean stain from fabric, immediately dry a the area with a blow dryer to help prevent a cleani ring. (See the previous NOTICE.) 6-45