2011 Subaru Forester Owner's Manual - Page 151

3-40 Instruments and controls www.homelink.com or call 1-800-3553515. Note the following information about this system. If your vehicle is equipped with the HomeLink® Wireless Control System, it complies with Part 15 of the Federal Communications Commission Rules in the U.S. and the RSS-210 of Industry Canada in Canada. Its operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes and modifications to this system by anyone other than an authorized service facility could void authorization to use this equipment. HomeLink® and the HomeLink® house are registered trademarks of Johnson Controls, Inc. and objects are out of the way of the garage door or other device to prevent potential harm or damage. . Do not use the HomeLink® Wireless Control System with a garage door opener that lacks the safety stop and reverse feature as required by applicable safety standards. A garage door opener which cannot detect an object, signaling the door to stop and reverse, does not meet these safety standards. Using a garage door opener without these features increases risk of serious injury or death. For more information, consult the HomeLink® website at www.homelink.com or call 1-800-355-3515. NOTE . After programming your HomeLink® Wireless Control System for the desired devices, retain the hand-held transmitters for further programming or device testing in the event of a problem. . It is recommended that you insert a new battery in the hand-held transmitter of a device to ensure correct programming. ! Garage door opener programming in the U.S.A. NOTE When programming the HomeLink® Wireless Control System for a garage door opener, it is suggested that you park the vehicle outside the garage. 1. Unplug the motor of the garage door opener from the outlet. CAUTION When programming the HomeLink® Wireless Control System to operate a garage door opener or an entrance gate, unplug the device's motor from the outlet during programming to prevent motor burnout. NOTE If any of the HomeLink® buttons are already programmed for other devices, skip step 2 because it clears the memory of all three buttons. WARNING . When programming the HomeLink® Wireless Control System, you may be operating a garage door opener or other device. Make sure that people