Brother International CS-80 Users Manual - English - Page 19

S2_brotherE.book Page 13 Thursday, February 13, 2003 11:03 AM Slide the bobbin winder shaft to the right. 5 Place the spool of thread for the bobbin onto 6 the bobbin thread spool pin. CAUTION G Two spool cap sizes are available, allowing you to choose a spool cap that best fits the size of spool being used. If the spool cap is too small for the spool 1 being used, the thread may catch on the slit in the spool or the needle may break. Slide the spool cap onto the bobbin thread 7 spool pin. With the rounded side of the spool cap positioned toward the left, slide the spool cap onto the bobbin thread spool pin as far as possible until the right side of the spool touches the right end of the bobbin thread spool pin. Note G If a spool of thread 12 mm (1/2 inch) in diameter and 75 mm (3 inch) high is inserted onto the bobbin thread spool pin, use the special spool cap. 2 1 1 12 mm (1/2 inch) 2 75 mm (3 inch) Winding/Installing the Bobbin 13