Brother International CS-80 Users Manual - English - Page 81
does not touch the zipper, otherwise
View all Brother International CS-80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
S2_brotherE.book Page 75 Thursday, February 13, 2003 11:03 AM Press the seam allowance so that the right side 4 (the side that will not be stitched) has an extra CAUTION 3 mm (1/8 inch). G When using zipper foot "I", be sure to select the straight stitch (center needle position), and slowly turn the balance wheel toward you to check that the 1 needle does not touch the presser foot. If a different stitch is selected or the needle hits the presser foot, the needle may 2 bend or break. 1 Wrong side of fabric 2 3 mm (1/8 inch) Sew the zipper to the piece of fabric with the 8 extra 3 mm (1/8 inch), starting from the base Align the zipper teeth with the pressed edge 5 of the fabric having the extra 3 mm (1/8 inch), of the zipper. and then baste or pin the zipper in place. 3 2 1 1 Zipper teeth 2 Basting stitching Attach the presser foot holder to the right pin 6 of zipper foot "I". If the stitching will be sewn on the right side, attach the presser foot holder to the left pin of the zipper foot. 1 I 2 CAUTION G When sewing, be sure that the needle does not touch the zipper, otherwise the needle may bend or break. When you are about 5 cm (2 inch) from the 9 end of the zipper, stop the sewing machine with the needle lowered (in the fabric), raise the presser foot lever, and then open the zipper and continue sewing. 1 Pin on the right side 2 Needle drop point • For details, refer to " Replacing the presser foot" (page 35). Select stitch . 7 • For details, refer to " Selecting stitching" (page 58). Zipper Insertion 75