Brother International CS-80 Users Manual - English - Page 35
Pulling up the bobbin thread
View all Brother International CS-80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
S2_brotherE.book Page 29 Thursday, February 13, 2003 11:03 AM Pulling up the bobbin thread Pull out about 10-15 cm (3/8-5/8 inch) of the 5 bobbin thread under the presser foot toward When making gathers or before free-motion quilting, the rear of the machine. first pull up the bobbin thread as described below. Insert the bobbin into the shuttle. 1 1 • Refer to steps 1 through 5 of " Installing the bobbin" (page 16). Pass the bobbin thread through the slot. 2 Do not cut the thread with the cutter. While lightly holding the upper thread with 3 your left hand, press (needle position button) twice to raise the needle. 1 Reattach the bobbin cover. 6 Insert the tab in the lower-left corner of the bobbin cover, and then lightly press down on the right side. 2 1 1 Needle position button X The bobbin thread is looped around the upper thread and can be pulled up. Carefully pull the upper thread upward to pull 4 out the end of the bobbin thread. Upper Threading 29