Brother International CS-80 Users Manual - English - Page 40
stopper, and then use the screwdriver
View all Brother International CS-80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
S2_brotherE.book Page 34 Thursday, February 13, 2003 11:03 AM GETTING READY Lower the needle-changing tool. 4 Insert the needle until it touches the needle 7 stopper, and then use the screwdriver to tighten the needle clamp screw. X The needle can be removed from the needle bar. Insert the new needle into the hole in the 5 needle-changing tool. Insert the needle with the flat side of the needle toward the rear of the machine. X The needle is installed. Lower the needle-changing tool off of the 8 needle. Lift up the needle-changing tool so that the 6 fork hooks onto the needle clamp screw. 34
GETTING READY
————————————————————————————————————————————————————————
34
4
Lower the needle-changing tool.
The needle can be removed from the needle
bar.
5
Insert the new needle into the hole in the
needle-changing tool.
Insert the needle with the flat side of the needle
toward the rear of the machine.
6
Lift up the needle-changing tool so that the
fork hooks onto the needle clamp screw.
7
Insert the needle until it touches the needle
stopper, and then use the screwdriver to
tighten the needle clamp screw.
The needle is installed.
8
Lower the needle-changing tool off of the
needle.
S2_brotherE.book
Page 34
Thursday, February 13, 2003
11:03 AM