Brother International FAX-1010 Service Manual - Page 146
Brother International FAX-1010 Manual
View all Brother International FAX-1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
(2) Change the detecting conditions and check that the indication on the LCD changes as follows: - Insert a document through the document front sensor, and the "F" of the FRE disappears. - Insert a document through the document rear sensor, and the "E" of the FRE disappears. - Open the recording paper cover ASSY, and the "RC" disappears. - Jam paper at the paper outlet, and the "JM" disappears. - Remove paper or open the paper front cover, and the "PH" disappears. - Remove the ribbon cartridge, and the "RX" disappears. - Lift up the handset, and the "HK" disappears. (Except for the FAX1010 and those versions equipped with a Binatone handset.) (3) To stop this operation, press the Stop key. The equipment beeps for one second and returns to the initial maintenance mode. 3.8 CIS Scanner Area Setting • Function The equipment sets the CIS scanner area and stores it into the E2PROM. This setting operation requires the "adjusting sheet A" to be used. • Operating Procedure (1) In the initial maintenance mode, set the "adjusting sheet A" on the document stacker. (2) Press the 5 key twice. The "SCANNER AREA SET" will appear on the LCD. The equipment checks and sets the area to be scanned. If no error is noted, the equipment returns to the initial maintenance mode. If any error is noted, the "SCANNER ERROR" will appear on the LCD. To return the equipment to the initial maintenance mode, press the I Stop key. 3.9 Equipment Error Code Indication • Function This function displays an error code of the last error on the LCD. • Operating Procedure (1) Press the 8 and 2 keys in this order in the initial maintenance mode. The LCD shows the "MACHINE ERROR_ _" (for 2-digit error code indication) or "MACHINE ERR _ _ _ _" (for 4-digit error code indication). (2) To stop this operation and return the equipment to the initial maintenance mode, press the Stop key.