Brother International FAX-1010 Service Manual - Page 70
Handset, Mount, models, except, FAX1010, Cover
View all Brother International FAX-1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
1.14 Handset Mount (for models except the FAX1010) Side Cover (for the FAX1010) (1) Disconnect the hook switch harness* from the main PCB. (2) Remove the two screws from the handset mount* or the side cover**. (3) Twist the handset mount* or the side cover** so that it tilts over to the left and its upper end works out of the bosses provided on the side cover L. (FAX1010) (Models except the FAX1010) Side cover L Side cover** tffl Thick portions "T" whose outer face should be flush with the outer face of the side cover L. Handset mount* Handset mount* 5 * For models except the FAX1010 ** For the FAX1010 (4) To disassemble the handset mount* for models except the FAX1010, unhook the two latches with a flat screwdriver. Upper mount Latch Latch Hook switch PCB Hook switch harness Through the cutout Lower mount Routing of the hook Underneath the switch harness hook switch PCB • Reassembling Notes • When assembling upper and lower mounts, route the hook switch harness underneath the hook switch PCB and through the cutout as shown above. Take care not to pinch the harness between the upper and lower mounts. • The front and rear upper edges "T" of the handset mount are thick. Be sure to make their outer face flush with the outer face of the side cover L. IV -26