Brother International FAX-1010 Service Manual - Page 51
disassemble
View all Brother International FAX-1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
(7) To disassemble the recording head ASSY, follow the steps below. 1) Remove the head protection plate by unhooking the two latches. 2) Turn the recording head ASSY upside down and release the head-power harness from the adhesive tape. 3) Place the recording head ASSY rightside up. 4) Push down both ends of the recording head and move it to the rear to release the tabs from the cutouts provided in the recorder frame as shown below. NOTE: Take care not to lose the three springs placed under the recording head. Head protection plate Ribbon sensor and actuator Tab Head-power harness Latches Recording head Tab Main-head harness Head springs Head spring 0 Bring the spring end into contact with the edge of the cutout. Recorder frame ■ Reassembling Notes • When reinstalling the recording head, make sure that the three head springs are set into place; that is, each spring end is in contact with the edge of the cutout as illustrated above. • Be sure to tape the head-power harness onto the bottom of the recorder frame. • When reinstalling the recording head ASSY, put the two harnesses under the center beam of the main frame as shown in Section 1.29. • After installation, check the routing of the main-head harness and head-power harness, referring to Section 1.29.