Brother International FAX-1010 Service Manual - Page 56
Paper, Roller, Chute
View all Brother International FAX-1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
1.6 Paper Feed Roller ASSY and Paper Feed Sub Chute (1) Remove the front cover sensing actuator from the paper feed roller shaft by pulling up the actuator's rear edge as shown below. Front cover sensing actuator Paper feed roller ASSY (Front) ti) N Pull up here to remove. Platen frame o Boss of the paperedge sensor actuator Front cover sensing actuator (2) At the left end of the paper feed roller ASSY (when viewed from the rear), remove the bushing by pulling its pawls outwards. (3) At the right end, remove the paper feed roller gear (Gear 55) by pulling its pawl outwards. Next, pull the paper feed roller shaft to the right until the left end of the shaft comes out of the main frame and then tilt the shaft to the right so that the bushing-fixed end can pass through the lower hole, and take it out to the left. Paper feed roller ASSY Bushing Paper feed roller gear (Gear 55) r4 O Pawled bushing O Lower hole (Rear) IV - 12