Brother International MFC-9460CDN IFAX Network Users Manual - English - Page 12

Internet fax TX Verification Mail 1 Transmission Verification Mail supports two separate functions. Verification Mail for sending allows you to 1 request notification from the receiving station that the Internet Fax or E-mail was received and processed. Verification Mail for receiving allows you to transmit a default report back to the sending station after successfully receiving and processing an Internet Fax or E-mail. To use this feature you must set the Notification option within the Setup Mail RX and Setup Mail TX options. Setup Mail TX 1 You can set the Notification option in the Setup Mail TX option to either On or Off. When switched to On an additional field of information is sent with the image data. This field is named "MDN". MDN (Message Disposition Notification): This field requests the status of the Internet Fax/E-mail message after delivery through the SMTP (Send Mail Transfer Protocol) transport system. Once the message has arrived at the receiver this data is used when the machine or user reads or prints the received Internet Fax or E-mail. For example, if the message is opened for reading or is printed the receiver sends back a notification to the original sending machine or user. The receiver must support the MDN field in order to be able to send a notification report, otherwise the request will be ignored. Setup Mail RX 1 There are three possible settings for this option On, MDN or Off. Receive Notification "On" When switched to "On" a fixed message is sent back to the sender to indicate successful reception and processing of the message. These fixed messages depend on the operation requested by the sender. Report messages consist of: SUCCESS: Received From Receive Notification "MDN" When switched to "MDN" a report as described above is sent back to the sender if the originating station sent the "MDN" field to request confirmation. Receive Notification "Off" Off switches all forms of receive notification Off, no message is sent back to the sender regardless of the request. Note To receive the TX verification mail properly, you must configure the following settings. • Sender • Switch Notification in the Setup Mail TX to on. • Switch Header in the Setup Mail RX to All or Subject+From+To. • Receiver • Switch Notification in the Setup Mail RX to on. 9