Brother International XR1300 Users Manual - English - Page 106
pitched noise
View all Brother International XR1300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
APPENDIX Symptom The fabric is wrinkled. Stitches are skipped. There is a highpitched noise while sewing. The fabric does not feed. The fabric feeds in the opposite direction. Possible cause How to put it right Reference The presser foot you are using is not Attach the presser foot that is correct appropriate for the type of stitch that for the type of stitch that you want to you want to sew. sew. page 79 The thread tension is incorrect. Adjust the tension of the upper thread. page 41, 96 You have not threaded the upper thread properly. Correct the upper threading. page 23 You have not used the right combination of fabric, thread and needle. Choose a thread and needle that are appropriate for the type of fabric. page 29 The needle is bent or blunt. The needle is incorrectly installed. Replace the needle. Correctly install the needle. page 30 Dust has accumulated under the needle plate or in the race. Remove the needle plate cover and clean the plate and the race. page 89 Dust has built up in the feed dogs or Remove the needle plate cover and in the race. clean the plate and the race. page 89 You have not threaded the upper thread properly. Correct the upper threading. page 23 Replace the bobbin case. The bobbin case is scratched. Contact your retailer or the nearest - authorized service center. You have not used bobbin that has been designed for this machine. Incorrect bobbins will not work properly. Only use a bobbin that has been designed for this machine. page 15 The feed dogs are lowered. Slide the feed dog position lever to . page 55, 65 The stitch is too fine. Lengthen the stitch length. page 38 You have not used the right combination of fabric, thread and needle. Choose a thread and needle that are appropriate for the type of fabric. page 29 The thread is tangled, for example, in the race. Remove the tangle thread. If the thread is tangled in the race, clean the race. page 89, 93 The presser foot you are using is not Attach the presser foot that is correct appropriate for the type of stitch that for the type of stitch that you want to you want to sew. sew. page 79 The needle is bent or blunt. Replace the needle. page 30 Zigzag foot "J" is slanted on a thick seam at the beginning of stitching. Use the presser foot locking pin (black button on the left side) on zigzag foot "J" to keep the presser foot level while sewing. page 43 The feed mechanism is damaged. Contact your retailer or the nearest authorized service center. - 104