Brother International XR1300 Users Manual - English - Page 68
Reinforcement Stitching
View all Brother International XR1300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
UTILITY STITCHES REINFORCEMENT STITCHING Reinforce points that will be subject to strain, such as sleeve holes, inseams and pocket corners. Pattern Presser Foot Twin Needle Walking Foot Reverse (Rev.)/ Reinforcement (Rfc.) Stitching Stitch Name Pattern No. Application Stitch Width [mm (inch.)] Auto Manual Stitch Length [mm (inch.)] Auto Manual Triple stretch stitch Attaching sleeves, sewing inseams, J 02 sewing stretch fabrics and decora- tive stitching 0.0 (0) 0.0-7.0 (0-1/4) 2.5 (3/32) 1.5-4.0 (1/16-3/16) ** Yes No ( J ) Bar tack stitch A 42 Reinforcing openings and areas where the seam easily comes loose 2.0 (1/16) 1.0-3.0 (1/16-1/8) 0.4 (1/64) 0.3-1.0 (1/64-1/16) No No *Auto Rfc.: Automatic Reinforcement **Select a stitch width of 5.0 mm (3/16 inch) or less. Rfc. * Auto Rfc. CAUTION ● Be sure to turn off the main power before replacing the presser foot. Otherwise, injuries may occur if the foot controller or (start/stop button) is accidentally pressed and the machine starts sewing. Triple stretch stitching Use triple stretch stitching to reinforce sleeve holes and inseams. Attach zigzag foot "J". a Determine the desired length of the bar tack. a Set the button guide plate on buttonhole foot "A" to the desired length. (The distance between the markings on the presser foot scale is 5 mm (3/16 inch).) 1 Select stitch . b Start sewing. c • For details, refer to "Starting to sew" (page 39). Bar tack stitching Bar tacks are used to reinforce points subject to strain, such as pocket corners and openings. As an example, the procedure for sewing bar tacks at pocket corners is described below. 2 3 a Presser foot scale b Length of bar tack c 5 mm (3/16 inch) • A bar tack with a maximum length of about 28 mm (1-1/8 inches) can be sewn. Attach buttonhole foot "A". b Select stitch . c 66