Canon EOS 10D EOS 10D INSTRUCTIONS - Page 172
Troubleshooting Guide
UPC - 750845811339
View all Canon EOS 10D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 172 highlights
Troubleshooting Guide If there is a problem, first refer to this Troubleshooting Guide. Power Source The battery cannot be recharged. You are using the wrong battery. s Use Battery Pack BP-511 or BP-512. (→p.7) The battery is not properly attached to the charger. s Attach the battery properly to the charger. (→p.22) The camera does not operate even when the < > switch is set to < >. The battery is exhausted. s Change the battery pack. (→p.22) The battery is not installed properly. s Install the battery properly. (→p.24) Battery compartment cover is not closed. s Close the battery compartment cover tightly. (→p.24) CF card slot cover is not closed. s Load the CF card firmly until the CF card eject button pops out, then close the CF card slot cover tightly. (→p.28) The access lamp still blinks even when the < > switch is set to < >. If you set the < > switch to < OFF> right after shooting, the access lamp will still blink for a few seconds while the image is recorded onto the CF card. s When the camera finishes recording the image to the CF card, the access lamp will stop blinking and the power will turn off. The battery The battery is not fully charged. becomes s Recharge the battery fully. (→p.22) exhausted quickly. The battery's service life has expired. s Replace the battery with a new one. (→p.174) The camera turns Auto power off is in effect. off by itself. s Set the < > switch to < (→p.142) > again or set auto power off to [Off]. Only the < > The battery has almost exhausted. icon is displayed on s Recharge the battery. (→p.22) the LCD panel. Camera is not operating properly. s Press the shutter button down halfway to reset the camera to normal. (→p.30) ∗ If the < > icon still appears, the camera needs repair. Take it to a Canon Service Center. (→back cover) 172