Cisco 7206VXR Configuration Guide - Page 103

Chapter 3 Installing a Cisco 7200 VXR Router Rack-Mounting a Cisco 7200 VXR Router Figure 3-5 Rack-Mounting the Chassis in a Four-Post Rack with Installed Cable-Management Brackets-Front Installation Shown 5 2 1 ENABLED 0 3 1 Cisco 7200 Series ENABLED PCMCIA EN TD TC RD RC LB CD TD TC RD RC LB CD TD TC RD RC LB CD TD TC RD RC LB CD 3 0 1 LINK 2 3 ENABLED ETHERNET 10BT FAST SERIAL EN RX 0 SLOT 1 EJECT SLOT 0 MII FE II MEN RJE4N5 RJL4IN5 K R 1O POWK TX RJ-45 RX CPU RESET 1 0 TX RX 0 2 MII 1 LINK TX RJ45 RX 3 2 TX TOKEN RING 6 FAST ETHERNET 4 ETHERNET-10BFL 2 FAST ETHERNET INPUT/OUTPUT CONTROLLER 0 RX 4 3 TX 1 2 84547 1 Rack-mount bracket 2 Cable-management bracket If you are rack-mounting a Cisco 7200 VXR router from the rear, the rack-mount brackets are installed at the rear of the chassis, and the cable-management brackets are installed at the front of the chassis. You must install both sets of brackets before you install the chassis in the rack. Attaching the Chassis Rack-Mount and Cable-Management Brackets This section explains how to install the rack-mount and cable-management brackets at the front and the rear of a Cisco 7200 VXR router. Before installing the chassis in the rack, you must install a rack-mount bracket on each side of the front or rear of the chassis. If you are rack-mounting the chassis from the front and you plan to use the cable-management brackets, you must install the cable-management brackets when you install the rack-mount brackets on the chassis. If you are rack-mounting the chassis from the rear, you may install the rack-mount and cable-management brackets separately; however, both sets of brackets must be installed on the chassis before the chassis is installed in the rack. The parts and tools required for installing the rack-mount and cable-management brackets are listed in Chapter 2, "Preparing for Installation," the "Tools and Parts Required" section on page 2-1. OL-5013-09 Cisco 7200 VXR Installation and Configuration Guide 3-7