Cisco 7206VXR Configuration Guide - Page 128
Ethernet and Fast Ethernet Straight-Through Cable Pinout, Ethernet Port to a Hub or
UPC - 746320975061
View all Cisco 7206VXR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Connecting I/O Controller, NPE-G1, or NPE-G2 Cables Chapter 3 Installing a Cisco 7200 VXR Router Figure 3-23 Ethernet port 1 TxD+ 2 TxD- Ethernet and Fast Ethernet Straight-Through Cable Pinout, Ethernet Port to a Hub or Repeater Hub 1 RxD+ 2 RxD- 38582 3 RxD+ 6 RxD- 3 TxD+ 6 TxD- Figure 3-24 Ethernet port 1 TxD+ 2 TxD- Ethernet and Fast Ethernet Crossover Cable Pinout, Ethernet Port to a DTE DTE 1 TxD+ 2 TxD- 38583 3 RxD+ 6 RxD- 3 RxD+ 6 RxD- To determine whether a UTP cable is a crossover cable or a straight-through cable, hold the two RJ-45 connectors next to each other so you can see the colored wires inside the ends, as shown in Figure 3-25. Figure 3-25 Crossover or Straight-Through Cable Identification H5663 Examine the sequence of colored wires to determine the type of cable, as follows: • Straight-through-The colored wires are in the same sequence at both ends of the cable. • Crossover-The first (far left) colored wire at one end of the cable is the third colored wire at the other end of the cable. 3-32 Cisco 7200 VXR Installation and Configuration Guide OL-5013-09