Cisco 7206VXR Configuration Guide - Page 59
NPE-G2 LEDs, Color, Function, LED Label, Status in the Power Up State
UPC - 746320975061
View all Cisco 7206VXR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Chapter 1 Cisco 7200 VXR Product Overview Field-Replaceable Units or not an I/O controller is in the system with the NPE-G1 or NPE-G2. The SLOT ACTIVE LED is on if there is a CompactFlash Disk in the NPE-G1. The CF ACTV LED is on if there is a CompactFlash Disk in the NPE-G2. Caution To prevent system errors and problems, use the CPU reset button only at the direction of your service representative. Table 1-24 lists LEDs common to all models of I/O controllers and describes their functions. Table 1-25 lists LEDs on the NPE-G2. Figure 1-21 lists the LEDs on the NPE-G1. Note LEDs are either on or off. The LED state (on or off), not the color, determines the status of connection. However, most LEDs are green when on, with the exception of the IO POWER OK LED, which is amber when in the on state. However, with the introduction of the NPE-G2, flashing LEDs are also indicative of activity. Table 1-24 I/O Controller LEDs LED Color ENABLED Green IO POWER Amber OK Slot 0 Slot 1 Green Function Indicates that the network processing engine or network services engine and the I/O controller are enabled for operation by the system; however, it does not mean that the Fast Ethernet port on the I/O controller is functional or enabled. This LED goes on during a successful router boot and remains on during normal operation of the router. Indicates that the I/O controller is on and receiving DC power from the router midplane. This LED comes on during a successful router boot and remains on during normal operation of the router. These LEDs indicate which PC Card slot is in use by coming on when either slot is being accessed by the system. These LEDs remain off during normal operation of the router. NPE-G2 LEDs Table 1-25 NPE-G2 LEDs LED Label LED Color LINK ACTV RJ-45 and SFP (Interfaces 0/1, 0/2, ports 0/3) Solid green Flashing green Off EN (Enable) RJ-45 ports only Solid green (Interfaces 0/1, 0/2, Off 0/3) FE LINK Fast Ethernet Solid green Management port Flashing green Off Status in the Power Up State Link with no activity. Link with activity. No link. RJ-45 port is selected. SFP port is selected. Link with no activity. Link with activity. No link. OL-5013-09 Cisco 7200 VXR Installation and Configuration Guide 1-41