Cisco 7206VXR Configuration Guide - Page 23

Chapter 1 Cisco 7200 VXR Product Overview Cisco 7204VXR Overview With the NPE-G1 or NPE-G2 installed and the Port Adapter Jacket Card installed in the I/O controller slot, an additional port adapter slot is available. Note If you have difficulty installing a processing engine or I/O controller in the lowest slot of a Cisco 7200 VXR router that is rack-mounted, remove the port adapters, processing engine and I/O controller from the chassis and reinstall them. Install the processing engine and I/O controller in the lowest slots first, then populate the slots above them, in a bottom-to-top order. Figure 1-1 Cisco 7204VXR Router-Front View 1 2 3 ENABLED 0 3 1 EN 1 0 ENABLED PCMCIA 1 2 2 3 3 0 1 LINK 2 3 4 ENABLED ETHERNET 10BT SERIAL-EIA/TIA-232 EN RX 0 TX 7 6 5 SLOT 1 EJECT SLOT 0 MII FE II MEN RJE4N5 RJL4IN5K R 1O POWK RJ-45 CPU RESET RX 1 TX RX 0 2 TX RX 3 TX MII LINK RJ45 Cisco 7200 SERIES XVR FAST ETHERNET 4 ETHERNET-10BFL 2 FAST ETHERNET INPUT/OUTPUT CONTROLLER 0 RX 4 TX 4 5 6 7 15889 1 Port adapters 2 Port adapter lever 3 I/O controller 4 PC Card slots 5 Optional Fast Ethernet interface (MII port and RJ-45 port) 6 Auxiliary port 7 Console port Note In Figure 1-1, a blank port adapter is installed in slot 3. To ensure adequate airflow across the port adapters, each port adapter slot must be filled with either a port adapter or a blank port adapter. The rear of the Cisco 7204VXR router provides access to the network processing engine or network services engine and up to two power supplies. (See Figure 1-2.) OL-5013-09 Cisco 7200 VXR Installation and Configuration Guide 1-5