Cisco 7206VXR Configuration Guide - Page 136

Connecting I/O Controller, NPE-G1, or NPE-G2 Cables Chapter 3 Installing a Cisco 7200 VXR Router The Cisco 7200 VXR routers ship with a roll-over cable. Connection to a terminal or a modem will require an RJ-45-to-DB-25 adapter, and possibly a DB-25-to-DB9 adapter. Refer to Table 3-17 for the cable and adapter configurations that can be used to connect terminals and modems to the Cisco 7200 VXR routers. Table 3-17 Asynchronous Device Cabling Options Access Server Port Console or auxiliary RJ-45 Cable Type Roll-over DB-25 Adapter FDTE1 Console or auxiliary Console or auxiliary Straight Roll-over FDCE MMOD2 1. The FDTE RJ-45-to-DB-25 adapter is labeled "Terminal". 2. The MMOD RJ-45-to-DB-25 adapter is labeled "Modem". End Device Terminal Terminal Modem RJ-45 Console Port Signals and Pinouts The NPE-G1, NPE-G2, and the C7200-I/O-2FE/E and C7200-I/O-GE+E I/O controllers do not support Data Carrier Detect (DCD). Table 3-18 lists the RJ-45 console port signals for the NPE-G1, NPE-G2, and the C7200-I/O-2FE/E and C7200-I/O-GE+E I/O controllers. Table 3-18 Console Port Signals for NPE-G1, NPE-G2, and C7200-I/O-2FE/E and C7200-I/O-GE+E Pin1 Signal Direction 1 CTS Out 2 DSR Out 3 RXD Out 4 GND - 6 TXD In 7 DTR In 8 RTS In 1. Any pin not referenced is not connected. Description Clear To Send (tracks RTS) Data Set Ready (always on) Receive Data Ground Transmit Data Data Terminal Ready Ready To Send RJ-45 Auxiliary Port Signals and Pinouts for the NPE-G2, NPE-G1 and I/O Controllers Table 3-19 lists the RJ-45 auxiliary port signals for the C7200-I/O-2FE/E and C7200-I/O-GE+E I/O controllers and NPE-G1, and NPE-G2 Table 3-19 Auxiliary Port Signals for NPE-G2, NPE-G1 and C7200-I/O-2FE/E and C7200-I/O-GE+E Pin1 Signal 1 RTS 2 DTR 3 TXD 42 RING Direction Out Out Out In Description Ready To Send Data Terminal Ready Transmit Data Ring Indication 3-40 Cisco 7200 VXR Installation and Configuration Guide OL-5013-09