Cisco 7206VXR Configuration Guide - Page 21
Description, Specification, 370W 1262 BTU - npe 400
UPC - 746320975061
View all Cisco 7206VXR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Chapter 1 Cisco 7200 VXR Product Overview Physical Description See Table 1-1 for the Cisco 7200 VXR physical specifications and power requirements: Table 1-1 Physical Specifications Description Specification Midplane Two primary PCI buses, and one secondary PCI bus • With an NPE-G2 or NPE-G1 and an I/O controller installed, the I/O controller does not use bandwidth points, and the NPE-G2 or NPE-G1 does use bandwidth points. The NPE-G2 or NPE-G1 does not use bandwidth points if installed without the I/O controller. • With an NSE-1, NPE-400, or NPE-300 installed: aggregate bandwidth of 900 Mbps1 • With n NPE-100, NPE-150, or NPE-200 installed: aggregate bandwidth of 600 Mbps Three primary PCI buses-With the NPE-G2 or NPE-G1 installed, no I/O controller, and the Port Adapter Jacket Card installed, three PCI buses are available. Aggregate bandwidth of the PCI buses is 900 Mbps. The third PCI bus goes to the Port Adapter Jacket Card and provides unlimited bandwidth for one port adapter. Dimensions (H x W x D) 5.25 in. x 16.8 in. x 17 in. (13.34 cm x 42.67 cm x 43.18 cm) Weight Heat dissipation Chassis fully configured with a network processing engine or network services engine, I/O controller, maximum number of port adapters, 2 power supplies, and a fan tray: ~ 50 lb (22.7 kg) 370W (1262 BTU2) Chassis fan noise levels-single speed fan Tested: • Front (I/O controller and port adapter side) 44.2 dB • Back (power supply side) 43.7 dB • Left (fan side) 47.2 dB • Right 44.8 dB Airflow Maximum: 65 dB ~80 cfm3 Temperature 32 to 104•F (0 to 40•C) operating; -4 to 149•F (-20 to 65•C) nonoperating Humidity 10 to 90% noncondensing Power Specifications AC-input voltage rating 100-240 VAC4 wide input with power factor correction AC-input current rating 5A5 at 100-240 VAC with the chassis fully configured AC-input frequency rating 50/60 Hz6 AC-input cable 18 AWG7 three-wire cable, with a three-lead IEC-320 receptacle on the power supply end, and a country-dependent plug on the power source end DC-output power 280W maximum (with either a single or dual power supply configuration) DC-input voltage rating -48 VDC8 nominal in North America -60 VDC nominal in the European Community OL-5013-09 Cisco 7200 VXR Installation and Configuration Guide 1-3