Cisco 7206VXR Configuration Guide - Page 109
Installing the NPE-G1 and NPE-G2 Cable-Management Brackets on a Rear-Mounted Router,
UPC - 746320975061
View all Cisco 7206VXR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Chapter 3 Installing a Cisco 7200 VXR Router Rack-Mounting a Cisco 7200 VXR Router Caution To prevent injury, review the safety precautions in Chapter 2, "Preparing for Installation," before installing the router in a rack. Installing the NPE-G1 and NPE-G2 Cable-Management Brackets on a Rear-Mounted Router Use the instructions in this section to attach the standard cable-management brackets if you have a rear-mounted router. If you wish to install the NPE-G1 or NPE-G2 optical cable-management bracket, see the "Installing the NPE-G1 and NPE-G2 Optical Cable-Management Bracket" section on page 3-11. Figure 3-12 Installing the Rear Cable-Management Brackets with the NPE-G1 or NPE-G2-Router Rear-Mounted 66750 EN 1 GIGABIT ETHERNET 0/1 LINK EN RJ45 RX GBIC TX GIGABIT ETHERNET 0/1 LINK EN RJ45 RX GBIC TX GIGABIT ETHERNET 0/1 LINK EN RJ45 RX GBIC TX NETWORK PROCESSING ENGINE - G1 CPU RESET C O M PAC T F L A S H 1 SLOT ACTIVE POWER ON CONSOLE AUX 1 Cable-management bracket screws If you have an NPE-G1 or NPE-G2 installed, you will want to install cable-management brackets on the rear of the router as well as on the front of the router. Step 1 Align the cable-management brackets with the rack-mount brackets. Step 2 Insert and tighten two screws for each bracket. The screws come with the cable-management brackets. This completes the procedure for installing the rack-mount brackets and cable-management brackets on a Cisco 7200 VXR router. Proceed to the "Installing the Chassis in the Rack" section on page 3-14. OL-5013-09 Cisco 7200 VXR Installation and Configuration Guide 3-13