Cisco 7206VXR Configuration Guide - Page 104
Installing the Brackets on the Front of the Chassis, Step 1
UPC - 746320975061
View all Cisco 7206VXR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Rack-Mounting a Cisco 7200 VXR Router Chapter 3 Installing a Cisco 7200 VXR Router Installing the Brackets on the Front of the Chassis To install the rack-mount and cable-management brackets on a Cisco 7200 VXR router for a front rack-mount configuration, complete the following steps: Step 1 Step 2 Step 3 Locate the threaded holes in the front sides of the chassis. If you want the front of the chassis protruding from the rack, align the first rack-mount bracket and the first cable-management bracket to the threaded holes in the right side of the chassis as shown in Figure 3-6. Thread two M4 x 8-mm Phillips flathead screws through both brackets and into the side of the chassis. Use a number 2 Phillips screwdriver to tighten the screws. (See Figure 3-6.) Figure 3-6 Installing the Rack-Mount Brackets on the Front of the Chassis so the Front Protrudes from the Rack 5 2 1 ENABLED 0 3 1 Cisco 7200 Series VXR ENABLED PCMCIA EN TD TC RD RC LB CD TD TC RD RC LB CD TD TC RD RC LB CD TD TC RD RC LB CD 3 0 1 LINK 2 3 ENABLED ETHERNET 10BT FAST SERIAL EN RX 0 SLOT 1 EJECT SLOT 0 FE MII II MEN RJE4N5 RJL4IN5K R 1O PWK O TX RJ-45 RX CPU RESET 1 0 TX RX 0 2 MII 1 LINK TX RJ45 RX 3 2 TX TOKEN RING 6 FAST ETHERNET 4 ETHERNET-10BFL 2 FAST ETHERNET INPUT/OUTPUT CONTROLLER 0 RX 4 3 TX 84521 1 2 1 Rack-mount bracket 2 Cable-management bracket Step 4 If you want the front of the chassis recessed in the rack, align the first rack-mount bracket to the threaded holes in the right side of the chassis as shown in Figure 3-7. Thread two M4 x 8-mm Phillips flathead screws through the bracket into the side of the chassis and use a number 2 Phillips screwdriver to tighten the screws. Then align the first cable-management bracket to the rack-mount bracket and thread two M4 x 8-mm Phillips flathead screws through the two brackets. Use a number 2 Phillips screwdriver to tighten the screws. (See Figure 3-7.) Cisco 7200 VXR Installation and Configuration Guide 3-8 OL-5013-09