Cisco 7206VXR Configuration Guide - Page 106
Installing the Standard Rear Cable-Management Brackets with an NPE-G1 or, NPE-G2-Router - modules
UPC - 746320975061
View all Cisco 7206VXR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Rack-Mounting a Cisco 7200 VXR Router Chapter 3 Installing a Cisco 7200 VXR Router Figure 3-8 Installing the Standard Rear Cable-Management Brackets with an NPE-G1 or NPE-G2-Router Front-Mounted H6423 1 GIGABIT ETHERNET 0/1 LINK EN RJ45 RX GBIC TX GIGABIT ETHERNET 0/1 LINK EN RJ45 RX GBIC TX GIGABIT ETHERNET 0/1 LINK EN RJ45 RX GBIC TX NETWORK PROCESSING ENGINE - G1 CPU RESET C O M PAC T F L A S H SLOT ACTIVE POWER OK CONSOLE AUX 1 66749 1 Cable-management bracket screws If you have an NPE-G1 or NPE-G2 installed, you will want to install standard cable-management brackets on the rear of the router as well as on the front of the router. Step 1 Step 2 Step 3 Step 4 If the back of the router protrudes from the rack, place the cable-management brackets against the router as shown in Figure 3-8. Insert two screws into each bracket, and tighten them to the router. Insert the GBIC cables or RJ-45 cables into the interface ports on the NPE-G1, or the SFP module cables or RJ-45 cables into the interface ports on the NPE-G2. Place the cables through the cable-management brackets. 3-10 Cisco 7200 VXR Installation and Configuration Guide OL-5013-09