Cisco 7971G-GE Administration Guide - Page 70

Overview of Options Configurable from a Phone Chapter 4 Configuring Settings on the Cisco Unified IP Phone Note The Cisco Unified IP Phone provides several methods you can use to reset or restore option settings, if necessary. For more information, see the "Resetting or Restoring the Cisco Unified IP Phone" section on page 9-13. Related Topics • Displaying a Configuration Menu, page 4-2 • Unlocking and Locking Options, page 4-3 • Overview of Options Configurable from a Phone, page 4-4 • Network Configuration Menu, page 4-5 • Device Configuration Menu, page 4-10 • Security Configuration Menu, page 4-29 Overview of Options Configurable from a Phone The settings that you can change on a phone fall into several categories, as shown in Table 4-1. For a detailed explanation of each setting and instructions for changing them, see the "Network Configuration Menu" section on page 4-5. Note There are several options on various configuration menus that are for display only or that you can configure from Cisco Unified Communications Manager. These options also are also described in this chapter. Table 4-1 Settings Configurable from the Phone Category Description General Network Settings Network Configuration Menu Option VLAN settings Admin. VLAN ID allows you to change the administrative VLAN used by the phone. PC VLAN allows the phone to interoperate with third-party switches that do not support a voice VLAN. Admin. VLAN ID PC VLAN Port settings Allow you to set the speed and duplex of the network and access ports. IPv4 Network Settings SW Port Configuration PC Port Configuration DHCP settings Dynamic Host Configuration Protocol (DHCP) automatically assigns IP address to devices when you connect them to the network. Cisco Unified IP Phones enable DHCP by default. DHCP DHCP Address Released Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 7.0 4-4 OL-15299-01