Cisco 877W Hardware Installation Guide - Page 44
Mounting Brackets on the Bottom Panel of the PoE Module, Step 1
UPC - 882658019579
View all Cisco 877W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
What to Do Next Chapter 3 Router and PoE Module Mounting Procedures Figure 3-3 Mounting Brackets on the Bottom Panel of the PoE Module 1 2 127092 1 1 Mounting brackets 2 Distance between the mounting brackets (1.70 in. [4.32 cm]) Perform the following steps to mount the PoE module on a wall: Step 1 Step 2 Step 3 Step 4 Step 5 Select a location on the wall on which you wish to mount the PoE module. See Figure 3-3 for the locations of the mounting brackets on the bottom panel. Mark on the wall where the mounting screws will be anchored, making sure that the marks line up vertically. Drill two holes 1.70 in. (4.32 cm) apart on the wall, using the drill bit size that is specified by the screw or hollow-wall anchor manufacturer. Anchor the screws into the wall, leaving 1/8 in. (0.32 cm) between the screw head and the wall for mounting the PoE module. Hang the PoE module on the wall, and secure the screws into the latches of the mounting brackets. Place the power supply on a horizontal surface. What to Do Next Connect devices to the router by following the instructions in Chapter 4, "Router Cabling Procedures." Cisco 850 Series and Cisco 870 Series Access Routers Hardware Installation Guide 3-6 OL-5331-01