Cisco SPA962-NA Administration Guide - Page 120
Control Timer Values (sec), Vertical Service Activation Codes, need to include them in dial-plan
View all Cisco SPA962-NA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
Regional Tab Control Timer Values (sec) Chapter 5 SPA900 Series Phone Field Reference Field Reorder Delay Call Back Expires Call Back Retry Intvl Call Back Delay VMWI Refresh Intvl Interdigit Long Timer Interdigit Short Timer Description Delay after far end hangs up before reorder tone is played. 0 = plays immediately, inf = never plays. Range: 0-255 seconds. The default is 5. Expiration time in seconds of a call back activation. Range: 0-65535 seconds. The default is 1800. Call back retry interval in seconds. Range: 0-255 seconds. The default is 30. Delay after receiving the first SIP 18x response before declaring the remote end is ringing. If a busy response is received during this time, the 900 Series phone still considers the call as failed and keeps on retrying. The default is 0.5. Interval between VMWI refresh to the CPE. The default is 0.5. Long timeout between entering digits when dialing. The interdigit timer values are used as defaults when dialing. The Interdigit_Long_Timer is used after any one digit, if all valid matching sequences in the dial plan are incomplete as dialed. Range: 0-64 seconds. The default is 10. Short timeout between entering digits when dialing. The Interdigit_Short_Timer is used after any one digit, if at least one matching sequence is complete as dialed, but more dialed digits would match other as yet incomplete sequences. Range: 0-64 seconds. The default is 3. Vertical Service Activation Codes Vertical Service Activation Codes are automatically appended to the dial-plan. There is no need to include them in dial-plan, although no harm is done if they are included. Field Call Return Code Description This code calls the last caller. The default is *69. 5-22 Linksys 900 Series IP Phone Administrator Guide Document Version 3.0