Compaq ProLiant 800 ProLiant 800 Servers Supporting Pentium II Processors and - Page 28
I/O Fan Assembly, Loosen the single thumbscrew securing the I/O fan assembly to the chassis
View all Compaq ProLiant 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
2-17 I/O Fan Assembly The I/O fan assembly is removed for replacement only. To remove the I/O fan assembly: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the top cover. See "Top Cover" earlier in this chapter. 3. Loosen the single thumbscrew securing the I/O fan assembly to the chassis . 4. Tilt the top of the fan assembly forward, then away from the chassis . 5. Disconnect the fan assembly power cable . 1 2 3 Figure 2-15. Removing the I/O fan assembly Reverse steps 1 through 5 to replace the I/O fan assembly. Compaq ProLiant 800 Servers Maintenance and Service Guide
2-17
Compaq ProLiant 800 Servers Maintenance and Service Guide
I/O Fan Assembly
The I/O fan assembly is removed for replacement only.
To remove the I/O fan assembly:
1.
Perform the preparation procedures. See
“
Preparation Procedures
”
earlier in this chapter.
2.
Remove the top cover. See
“
Top Cover
”
earlier in this chapter.
3.
Loosen the single thumbscrew securing the I/O fan assembly to the chassis
.
4.
Tilt the top of the fan assembly forward, then away from the chassis
.
5.
Disconnect the fan assembly power cable
.
1
2
3
Figure 2-15.
Removing the I/O fan assembly
Reverse steps 1 through 5 to replace the I/O fan assembly.