Compaq ProLiant 800 ProLiant 800 Servers Supporting Pentium II Processors and - Page 31
Processor, Push in the latches on each side of the processor until you hear two clicks
View all Compaq ProLiant 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
2-20 Removal and Replacement Procedures Processor The processor is removed for replacement or for the replacement of the system board. To remove the processor: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the left side access panel. See "Left Side Access Panel" earlier in this chapter. 3. Push in the latches on each side of the processor until you hear two clicks . This locks the tabs in the open position. 4. Lift the processor from the system board . 2 1 Figure 2-18. Removing the processor Reverse steps 1 through 4 to replace the processor.
2-20
Removal and Replacement Procedures
Processor
The processor is removed for replacement or for the replacement of the system board.
To remove the processor:
1.
Perform the preparation procedures. See
“
Preparation Procedures
”
earlier in this chapter.
2.
Remove the left side access panel. See
“
Left Side Access Panel
”
earlier in this chapter.
3.
Push in the latches on each side of the processor until you hear two clicks
. This locks
the tabs in the open position.
4.
Lift the processor from the system board
.
2
1
Figure 2-18.
Removing the processor
Reverse steps 1 through 4 to replace the processor.