Compaq ProLiant 800 ProLiant 800 Servers Supporting Pentium II Processors and - Page 37
Power Supply, Disconnect all cables from the power supply.
View all Compaq ProLiant 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
2-26 Removal and Replacement Procedures Power Supply The power supply is removed for replacement only. To remove the power supply: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the left side access panel. See "Left Side Access Panel" earlier in this chapter. 3. Disconnect all cables from the power supply. 4. Remove the four T-15 screws securing the power supply to the back of the chassis . 5. Pull the power supply out the side of the chassis . 1 2 Figure 2-23. Removing the power supply Reverse steps 1 through 5 to replace the power supply.
2-26
Removal and Replacement Procedures
Power Supply
The power supply is removed for replacement only.
To remove the power supply:
1.
Perform the preparation procedures. See
“
Preparation Procedures
”
earlier in this chapter.
2.
Remove the left side access panel. See
“
Left Side Access Panel
”
earlier in this chapter.
3.
Disconnect all cables from the power supply.
4.
Remove the four T-15 screws securing the power supply to the back of the chassis
.
5.
Pull the power supply out the side of the chassis
.
2
1
Figure 2-23.
Removing the power supply
Reverse steps 1 through 5 to replace the power supply.