D-Link DSN-5000-10 Hardware Reference Guide for DSN-5000-10 - Page 3

Safety Information There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery pack only with the same or equivalent type recommended by the manufacturer. Do not dispose of the battery along with household waste. Contact your local waste disposal agency for the address of the nearest battery deposit site. This product also uses a lithium coin cell battery. The lithium coin cell battery is a long-life battery, and it is very possible that you will never need to replace it. However, should you need to replace it, consult your service documentation. Do not dispose of the battery along with household waste. Contact your local waste disposal agency for the address of the nearest battery deposit site. CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. The iS512-10G product requires usage of laser transceivers (SFPs) to be installed. Such installation of any installed SFP must comply with the following: 1. The SFP to be installed must be UL Recognized as I.T.E. 2. The Laser Class of the SFP to be installed must be Class 1. 3. The transceivers of the SFP to be installed must comply with U.S. Code of Federal Regulations, 21 CFR 1040. 4. Those transceivers of the SFP to be installed must conform to the applicable requirements of 21 CFR Subchapter J. Following are the safety agency certifications that the xStack Storage enclosure has met: CSA 60950-1 UL 60950-1 IEC 60950-1 EN 60950-1 Compliance Information FCC Class A CE Class A C-Tick Class A VCCI Class A DSN-5000 series Hardware Reference Guide iii