D-Link DSN-5000-10 Hardware Reference Guide for DSN-5000-10 - Page 45

Replacing the I/O Module on the Expansion Array

Get D-Link DSN-5000-10 PDF manuals and user guides
UPC - 790069324024
View all D-Link DSN-5000-10 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 45 highlights

A.4 Replacing the I/O Module on the Expansion Array Use the following procedure to replace the I/O module on the expansion array. 1. Power down the DSN-5000 series primary and DSN-5000-10 expansion array and remove the power cords from the back panel. 2. Squeeze down on the top of the levers on either side of the I/O module on the DSN- 5000-10 expansion array and pull down to disengage the module, then pull the module straight out of the enclosure. 3. Install a replacement I/O module in the expansion array by keeping the levers on the left and right sides down, then slide the module into the enclosure until you feel it engage into place. 4. Replace the power cords and power on the DSN-5000 series primary array and DSN-500010 expansion array. Figure A-5. Removing the I/O Module on the Expansion Array (Slot #0 shown) DSN-5000 series Hardware Reference Guide 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
DSN-5000 series Hardware Reference Guide
37
A.4
Replacing the I/O Module on the Expansion Array
Use the following procedure to replace the I/O module on the expansion array.
1.
Power down the DSN-5000 series primary and DSN-5000-10 expansion array and remove
the power cords from the back panel.
2.
Squeeze down on the top of the levers on either side of the I/O module on the DSN-
5000-10 expansion array and pull down to disengage the module, then pull the module
straight out of the enclosure.
3.
Install a replacement I/O module in the expansion array by keeping the levers on the
left and right sides down, then slide the module into the enclosure until you feel it
engage into place.
4.
Replace the power cords and power on the DSN-5000 series primary array and DSN-5000-
10 expansion array.
Figure A-5. Removing the I/O Module on the Expansion Array (Slot #0 shown)