Dell Alienware m15 R2 Service Manual - Page 32

Installing the left I/O-board, Prerequisites, About this task, Steps

Get Dell Alienware m15 R2 PDF manuals and user guides View all Dell Alienware m15 R2 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

4. Remove the two screws (M2x3) that secure the left I/O-board cable connecting the left I/O-board and the system board. 5. Lift the left I/O-board cable from the left I/O-board and the system board. 6. Disconnect the antenna cables from the wireless card. 7. Lift the latch and disconnect the power-button assembly-cable from the left I/O-board. 8. Remove the screw (M2x3) that secures the left I/O-board to the palm-rest assembly. 9. Lift the left I/O-board off the palm-rest assembly. Installing the left I/O-board Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the left I/O-board and provides a visual representation of the installation procedure. Steps 1. Using the alignment post, place the left I/O-board on the palm-rest assembly. 2. Replace the screw (M2x3) that secures the left I/O-board to the palm-rest assembly. 32

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
4.
Remove the two screws (M2x3) that secure the left I/O-board cable connecting the left I/O-board and the system board.
5.
Lift the left I/O-board cable from the left I/O-board and the system board.
6.
Disconnect the antenna cables from the wireless card.
7.
Lift the latch and disconnect the power-button assembly-cable from the left I/O-board.
8.
Remove the screw (M2x3) that secures the left I/O-board to the palm-rest assembly.
9.
Lift the left I/O-board off the palm-rest assembly.
Installing the left I/O-board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the left I/O-board and provides a visual representation of the installation procedure.
Steps
1.
Using the alignment post, place the left I/O-board on the palm-rest assembly.
2.
Replace the screw (M2x3) that secures the left I/O-board to the palm-rest assembly.
32